The output impedance of current-shunt feedback amplifier（）；the output impedance of its op-amp.
The output impedance of current-shunt feedback amplifier（）；the output impedance of its op-amp.
A.is increased when compared to
B.is decreased when compared to
C.is reduced by half when compared to
D.has no effect on
正确答案：is increased when compared to
Tag：
时间：2024-01-15 10:34:27
- 上一篇：Calculate the voltage gain for voltage series feedback when the amplifier gain is A = -2000 and F = -1/50.（）
- 下一篇：An amplifier has a gain-bandwidth product of 200 MHz.A feedback network is added that has a feedback factor（1 + βA） of 18.88.What is the gain-bandwidth product for the circuit with the added feedback network？（）
相关答案
- 1.The feedback circuit connection shown here is（）.
- 2.The power that an amplifier delivers to a load is equal to the difference between the power that the circuit draws from the power supply and the power that the circuit dissipates.（）。
- 3.Power amplifiers are typically used to drive low impedance loads.（）。
- 4.The maximum theoretical efficiency of an RC-coupled class A amplifier is（）.
- 5.Crossover distortion in class B amplifiers is prevented by（）.
- 6.A class B amplifier（not push-pull）（）.
- 7.An active filter that provides a constant output for input signals above
- 8.A second order low-pass filter has a high-end roll-off of（）.
- 9.A summing integrator is an op-amp integrator that has（）.
- 10.If the input voltage is 0.25 V and the output is -2.5 V， the value of must be（）.
热门答案
- 1.The bandwidth of an amplifier is（）.
- 2.When a given op-amp has a common-mode input of 10 V， the output of the device is 10 V.；When the device has a differential input of 2 mV， the output of the device is 10 V.What is the CMPR of the device？（）
- 3.The inverting and noninverting inputs to an op-amp are used to drive a（n）（）amplifier.
- 4.The operational amplifier will only slightly amplify signals（）.
- 5.Under difference-mode operation， the difference-mode voltage gain for this circuit is（）.
- 6.An amplifier has a midband power gain of 24，500.What is the value of the power gain in dB for the circuit？（）
- 7.Negative dB values represent（）.
- 8.If several identical stages of amplifiers， each having the exact same upper and lower cutoff frequencies， are connected in cascade， then the bandwidth of the resulting amplifier will（）.
- 9.The（）；FET amplifier has low input impedance， high output impedance， and high voltage gain.
- 10.The（）；amplifier has high input impedance， low output impedance， and low voltage gain.