The bandwidth of an amplifier is（）.
The bandwidth of an amplifier is（）.
A.the range of frequencies over which gain remains relatively constant
B.the range of frequencies between the lower and upper 3 dB frequencies
C.the range of frequencies found using；
Tag：
时间：2024-01-15 10:34:16
相关答案
- 1.The inverting and noninverting inputs to an op-amp are used to drive a（n）（）amplifier.
- 2.The operational amplifier will only slightly amplify signals（）.
- 3.Under difference-mode operation， the difference-mode voltage gain for this circuit is（）.
- 4.An amplifier has a midband power gain of 24，500.What is the value of the power gain in dB for the circuit？（）
- 5.Negative dB values represent（）.
- 6.If several identical stages of amplifiers， each having the exact same upper and lower cutoff frequencies， are connected in cascade， then the bandwidth of the resulting amplifier will（）.
- 7.The（）；FET amplifier has low input impedance， high output impedance， and high voltage gain.
- 8.The（）；amplifier has high input impedance， low output impedance， and low voltage gain.
- 9.The FET version of the BJT'；s common-emitter configuration is the（）circuit.
- 10.A JFET can be biased in several different ways.The common method（s） of biasing an n-channel JFET is（are）（）.
热门答案
- 1.The primary difference between JFETs and depletion-type MOSFETs is（）.
- 2.Which of the following biasing circuits can be used with E-MOSFETs？（）
- 3.Generally， it is good design practice for linear amplifiers to have operating points that close to（）.
- 4.This graphical solution represents（）.
- 5.FETs usually（）.
- 6.In the family of FETs， you can expect to find（）.
- 7.The region of the JFET drain curve that lies between pinch-off and breakdown is called（）.
- 8.Shockley'；s equation defines the（）of the FET and are unaffected by the network in which the device is employeD.
- 9.The voltage gain of a very well-designed common collector amplifier configuration， using a pnp transistor， is（）.
- 10.A transistor amplifier has an input signal applied to its emitter terminal and an output signal taken from its collector terminal.The amplifier is a（n）（）.