The primary difference between JFETs and depletion-type MOSFETs is（）.
The primary difference between JFETs and depletion-type MOSFETs is（）.
A.JFETs can have positive values of and levels of drain current that exceed
B.depletion-type MOSFETs can have positive values of and levels of that exceed
C.depletion-type MOSFETs can have only positive of
正确答案：depletion-type MOSFETs can have positive values of and levels of that exceed
Tag：
时间：2024-01-15 10:34:05
相关答案
- 1.Generally， it is good design practice for linear amplifiers to have operating points that close to（）.
- 2.This graphical solution represents（）.
- 3.FETs usually（）.
- 4.In the family of FETs， you can expect to find（）.
- 5.The region of the JFET drain curve that lies between pinch-off and breakdown is called（）.
- 6.Shockley'；s equation defines the（）of the FET and are unaffected by the network in which the device is employeD.
- 7.The voltage gain of a very well-designed common collector amplifier configuration， using a pnp transistor， is（）.
- 8.A transistor amplifier has an input signal applied to its emitter terminal and an output signal taken from its collector terminal.The amplifier is a（n）（）.
- 9.Calculate the voltage gain for this circuit.（）
- 10.The transistor model replaces the（）；with the junction diode's ac resistance.
热门答案
- 1.Given this configuration， determine the input impedance if VS = 40 mV， Rsense = 0.5 kΩ， and the input current is 20 μA.（）
- 2.Voltage-divider bias stability is（）.
- 3.The term quiescent means（）.
- 4.The difference between the resulting equations for a network in which an npn transistor has been replaced by a pnp transistor is（）.
- 5.Calculate the collector-emitter voltage for this emitter-stabilized circuit.（）；
- 6.When a BJT is biased in the cutoff region the collector-to-emitter voltage is typically equal to（）.
- 7.The condition where increase in bias current will not cause further increases in collector current is called（）.
- 8.BJTs are commonly used as（）.
- 9.When a BJT is operating in the active region， the voltage drop from the base to the emitter is approximately equal to the（）。
- 10.In the active region， the base-emitter junction（）.