Calculate the collector-emitter voltage for this emitter-stabilized circuit.（）；
Calculate the collector-emitter voltage for this emitter-stabilized circuit.（）；
A.4.32 V
B.10.68 V
C.0.1335 V
D.14.24 V
正确答案：4.32 V
Tag：
时间：2024-01-15 10:33:46
相关答案
- 1.The condition where increase in bias current will not cause further increases in collector current is called（）.
- 2.BJTs are commonly used as（）.
- 3.When a BJT is operating in the active region， the voltage drop from the base to the emitter is approximately equal to the（）。
- 4.In the active region， the base-emitter junction（）.
- 5.The circuit shown here is a（）.
- 6.Which of the following circuits is used to eliminate a portion of a signal？（）.
- 7.The resistor voltage and resistor current in this circuit are（）.
- 8.What is the value of the voltage dropped across forward-biased silicon diodes that are connected in parallel with each other？（）.
- 9.When a p-n junction is reverse-biased， its junction resistance is（）.
- 10.The piecewise linear model， equivalent circuit of the diode consists of（）.
热门答案
- 1.When a diode is doped with either a pentavalent or a trivalent impurity its resistance will（）.
- 2.The characteristic of an ideal diode are those of a switch that can conduct current（）；.
- 3.Which of the following is not a commonly used semiconductor material'？（）
- 4.测得某放大电路的输入正弦电压和电流的峰值分别为10mV和10μA，在负载电阻为2KΩ时，测得输出正弦电压信号的峰值为2V。试计算该放大电路的电流放大倍数（）
- 5.测得某放大电路的输入正弦电压和电流的峰值分别为10mV和10μA，在负载电阻为2KΩ时，测得输出正弦电压信号的峰值为2V。试计算该放大电路的电压放大倍数（）
- 6.由于放大电路对信号中不同频率产生的（）不同而产生的波形失真，称为相位失真
- 7.由于放大电路对含有多种频率信号的（）不同而产生的波形失真，称为幅度失真
- 8.放大电路对不同频率的正弦信号的稳态响应特性简称为（）
- 9.已知某放大电路的输出电阻为3KΩ，在接有4KΩ负载电阻时，测得输出电压为2V。在输入电压不变的条件，断开负载电阻，输出电压将上升到（）
- 10.某放大电路在接有2KΩ负载电阻时，测得输出电压为3V，在输入电压不变的情况下断开负载电阻，输出电压上升到7.5V，说明该放大电路的输出电阻为（）