In the family of FETs， you can expect to find（）.
In the family of FETs， you can expect to find（）.
A.an；n-channel type
B.a；p-channel type
C.unipolar structure
正确答案：an；n-channel type；a；p-channel type；unipolar structure
Tag：
时间：2024-01-15 10:33:59
相关答案
- 1.Shockley'；s equation defines the（）of the FET and are unaffected by the network in which the device is employeD.
- 2.The voltage gain of a very well-designed common collector amplifier configuration， using a pnp transistor， is（）.
- 3.A transistor amplifier has an input signal applied to its emitter terminal and an output signal taken from its collector terminal.The amplifier is a（n）（）.
- 4.Calculate the voltage gain for this circuit.（）
- 5.The transistor model replaces the（）；with the junction diode's ac resistance.
- 6.Given this configuration， determine the input impedance if VS = 40 mV， Rsense = 0.5 kΩ， and the input current is 20 μA.（）
- 7.Voltage-divider bias stability is（）.
- 8.The term quiescent means（）.
- 9.The difference between the resulting equations for a network in which an npn transistor has been replaced by a pnp transistor is（）.
- 10.Calculate the collector-emitter voltage for this emitter-stabilized circuit.（）；
热门答案
- 1.When a BJT is biased in the cutoff region the collector-to-emitter voltage is typically equal to（）.
- 2.The condition where increase in bias current will not cause further increases in collector current is called（）.
- 3.BJTs are commonly used as（）.
- 4.When a BJT is operating in the active region， the voltage drop from the base to the emitter is approximately equal to the（）。
- 5.In the active region， the base-emitter junction（）.
- 6.The circuit shown here is a（）.
- 7.Which of the following circuits is used to eliminate a portion of a signal？（）.
- 8.The resistor voltage and resistor current in this circuit are（）.
- 9.What is the value of the voltage dropped across forward-biased silicon diodes that are connected in parallel with each other？（）.
- 10.When a p-n junction is reverse-biased， its junction resistance is（）.