The transistor model replaces the（）；with the junction diode's ac resistance.
The transistor model replaces the（）；with the junction diode's ac resistance.
A.collector-base junction
B.collector-emitter junction
C.emitter（）base junction
正确答案：emitter（）base junction
Tag：
时间：2024-01-15 10:33:54
相关答案
- 1.Voltage-divider bias stability is（）.
- 2.The term quiescent means（）.
- 3.The difference between the resulting equations for a network in which an npn transistor has been replaced by a pnp transistor is（）.
- 4.Calculate the collector-emitter voltage for this emitter-stabilized circuit.（）；
- 5.When a BJT is biased in the cutoff region the collector-to-emitter voltage is typically equal to（）.
- 6.The condition where increase in bias current will not cause further increases in collector current is called（）.
- 7.BJTs are commonly used as（）.
- 8.When a BJT is operating in the active region， the voltage drop from the base to the emitter is approximately equal to the（）。
- 9.In the active region， the base-emitter junction（）.
- 10.The circuit shown here is a（）.
热门答案
- 1.Which of the following circuits is used to eliminate a portion of a signal？（）.
- 2.The resistor voltage and resistor current in this circuit are（）.
- 3.What is the value of the voltage dropped across forward-biased silicon diodes that are connected in parallel with each other？（）.
- 4.When a p-n junction is reverse-biased， its junction resistance is（）.
- 5.The piecewise linear model， equivalent circuit of the diode consists of（）.
- 6.When a diode is doped with either a pentavalent or a trivalent impurity its resistance will（）.
- 7.The characteristic of an ideal diode are those of a switch that can conduct current（）；.
- 8.Which of the following is not a commonly used semiconductor material'？（）
- 9.测得某放大电路的输入正弦电压和电流的峰值分别为10mV和10μA，在负载电阻为2KΩ时，测得输出正弦电压信号的峰值为2V。试计算该放大电路的电流放大倍数（）
- 10.测得某放大电路的输入正弦电压和电流的峰值分别为10mV和10μA，在负载电阻为2KΩ时，测得输出正弦电压信号的峰值为2V。试计算该放大电路的电压放大倍数（）