Given this configuration， determine the input impedance if VS = 40 mV， Rsense = 0.5 kΩ， and the input current is 20 μA.（）
Given this configuration， determine the input impedance if VS = 40 mV， Rsense = 0.5 kΩ， and the input current is 20 μA.（）
A.1.5 MΩ
B.5.822 MΩ
C.1，500 Ω
D.582 kΩ
正确答案：1，500 Ω
Tag：
时间：2024-01-15 10:33:52
相关答案
- 1.The term quiescent means（）.
- 2.The difference between the resulting equations for a network in which an npn transistor has been replaced by a pnp transistor is（）.
- 3.Calculate the collector-emitter voltage for this emitter-stabilized circuit.（）；
- 4.When a BJT is biased in the cutoff region the collector-to-emitter voltage is typically equal to（）.
- 5.The condition where increase in bias current will not cause further increases in collector current is called（）.
- 6.BJTs are commonly used as（）.
- 7.When a BJT is operating in the active region， the voltage drop from the base to the emitter is approximately equal to the（）。
- 8.In the active region， the base-emitter junction（）.
- 9.The circuit shown here is a（）.
- 10.Which of the following circuits is used to eliminate a portion of a signal？（）.
热门答案
- 1.The resistor voltage and resistor current in this circuit are（）.
- 2.What is the value of the voltage dropped across forward-biased silicon diodes that are connected in parallel with each other？（）.
- 3.When a p-n junction is reverse-biased， its junction resistance is（）.
- 4.The piecewise linear model， equivalent circuit of the diode consists of（）.
- 5.When a diode is doped with either a pentavalent or a trivalent impurity its resistance will（）.
- 6.The characteristic of an ideal diode are those of a switch that can conduct current（）；.
- 7.Which of the following is not a commonly used semiconductor material'？（）
- 8.测得某放大电路的输入正弦电压和电流的峰值分别为10mV和10μA，在负载电阻为2KΩ时，测得输出正弦电压信号的峰值为2V。试计算该放大电路的电流放大倍数（）
- 9.测得某放大电路的输入正弦电压和电流的峰值分别为10mV和10μA，在负载电阻为2KΩ时，测得输出正弦电压信号的峰值为2V。试计算该放大电路的电压放大倍数（）
- 10.由于放大电路对信号中不同频率产生的（）不同而产生的波形失真，称为相位失真