The（）；amplifier has high input impedance， low output impedance， and low voltage gain.
The（）；amplifier has high input impedance， low output impedance， and low voltage gain.
A.common-gate
B.common-drain
C.common-source
正确答案：common-drain
Tag：
时间：2024-01-15 10:34:08
相关答案
- 1.A JFET can be biased in several different ways.The common method（s） of biasing an n-channel JFET is（are）（）.
- 2.The primary difference between JFETs and depletion-type MOSFETs is（）.
- 3.Which of the following biasing circuits can be used with E-MOSFETs？（）
- 4.Generally， it is good design practice for linear amplifiers to have operating points that close to（）.
- 5.This graphical solution represents（）.
- 6.FETs usually（）.
- 7.In the family of FETs， you can expect to find（）.
- 8.The region of the JFET drain curve that lies between pinch-off and breakdown is called（）.
- 9.Shockley'；s equation defines the（）of the FET and are unaffected by the network in which the device is employeD.
- 10.The voltage gain of a very well-designed common collector amplifier configuration， using a pnp transistor， is（）.
热门答案
- 1.A transistor amplifier has an input signal applied to its emitter terminal and an output signal taken from its collector terminal.The amplifier is a（n）（）.
- 2.Calculate the voltage gain for this circuit.（）
- 3.The transistor model replaces the（）；with the junction diode's ac resistance.
- 4.Given this configuration， determine the input impedance if VS = 40 mV， Rsense = 0.5 kΩ， and the input current is 20 μA.（）
- 5.Voltage-divider bias stability is（）.
- 6.The term quiescent means（）.
- 7.The difference between the resulting equations for a network in which an npn transistor has been replaced by a pnp transistor is（）.
- 8.Calculate the collector-emitter voltage for this emitter-stabilized circuit.（）；
- 9.When a BJT is biased in the cutoff region the collector-to-emitter voltage is typically equal to（）.
- 10.The condition where increase in bias current will not cause further increases in collector current is called（）.