The feedback circuit connection shown here is（）.
The feedback circuit connection shown here is（）.
A.voltage series feedback
B.voltage shunt feedback
C.current series feedback
D.current shunt feedback
正确答案：voltage series feedback
Tag：
时间：2024-01-15 10:34:26
相关答案
- 1.Power amplifiers are typically used to drive low impedance loads.（）。
- 2.The maximum theoretical efficiency of an RC-coupled class A amplifier is（）.
- 3.Crossover distortion in class B amplifiers is prevented by（）.
- 4.A class B amplifier（not push-pull）（）.
- 5.An active filter that provides a constant output for input signals above
- 6.A second order low-pass filter has a high-end roll-off of（）.
- 7.A summing integrator is an op-amp integrator that has（）.
- 8.If the input voltage is 0.25 V and the output is -2.5 V， the value of must be（）.
- 9.The bandwidth of an amplifier is（）.
- 10.When a given op-amp has a common-mode input of 10 V， the output of the device is 10 V.；When the device has a differential input of 2 mV， the output of the device is 10 V.What is the CMPR of the device？（）
热门答案
- 1.The inverting and noninverting inputs to an op-amp are used to drive a（n）（）amplifier.
- 2.The operational amplifier will only slightly amplify signals（）.
- 3.Under difference-mode operation， the difference-mode voltage gain for this circuit is（）.
- 4.An amplifier has a midband power gain of 24，500.What is the value of the power gain in dB for the circuit？（）
- 5.Negative dB values represent（）.
- 6.If several identical stages of amplifiers， each having the exact same upper and lower cutoff frequencies， are connected in cascade， then the bandwidth of the resulting amplifier will（）.
- 7.The（）；FET amplifier has low input impedance， high output impedance， and high voltage gain.
- 8.The（）；amplifier has high input impedance， low output impedance， and low voltage gain.
- 9.The FET version of the BJT'；s common-emitter configuration is the（）circuit.
- 10.A JFET can be biased in several different ways.The common method（s） of biasing an n-channel JFET is（are）（）.