Power amplifiers are typically used to drive low impedance loads.（）。
Power amplifiers are typically used to drive low impedance loads.（）。
A.正确
B.错误
正确答案：正确
Tag：
时间：2024-01-15 10:34:24
相关答案
- 1.Crossover distortion in class B amplifiers is prevented by（）.
- 2.A class B amplifier（not push-pull）（）.
- 3.An active filter that provides a constant output for input signals above
- 4.A second order low-pass filter has a high-end roll-off of（）.
- 5.A summing integrator is an op-amp integrator that has（）.
- 6.If the input voltage is 0.25 V and the output is -2.5 V， the value of must be（）.
- 7.The bandwidth of an amplifier is（）.
- 8.When a given op-amp has a common-mode input of 10 V， the output of the device is 10 V.；When the device has a differential input of 2 mV， the output of the device is 10 V.What is the CMPR of the device？（）
- 9.The inverting and noninverting inputs to an op-amp are used to drive a（n）（）amplifier.
- 10.The operational amplifier will only slightly amplify signals（）.
热门答案
- 1.Under difference-mode operation， the difference-mode voltage gain for this circuit is（）.
- 2.An amplifier has a midband power gain of 24，500.What is the value of the power gain in dB for the circuit？（）
- 3.Negative dB values represent（）.
- 4.If several identical stages of amplifiers， each having the exact same upper and lower cutoff frequencies， are connected in cascade， then the bandwidth of the resulting amplifier will（）.
- 5.The（）；FET amplifier has low input impedance， high output impedance， and high voltage gain.
- 6.The（）；amplifier has high input impedance， low output impedance， and low voltage gain.
- 7.The FET version of the BJT'；s common-emitter configuration is the（）circuit.
- 8.A JFET can be biased in several different ways.The common method（s） of biasing an n-channel JFET is（are）（）.
- 9.The primary difference between JFETs and depletion-type MOSFETs is（）.
- 10.Which of the following biasing circuits can be used with E-MOSFETs？（）